Must peaking alone be carried out at the centre of the template. I.e the weld joints Can it also be measured at the side?
Physics
ScanSolve AI Answer
Answer
No, Engr., peaking does not have to be measured only at the center of the template or weld joint.
Peaking can occur at any point along the length or circumference of the joint where the two components are misaligned. Therefore, you should use the template and taper scale to check for peaking at various locations along the joint, including the sides, to ensure the entire joint meets the required specifications for alignment.
Was this helpful?
Still stuck on this one?
Ask a follow-up, and the answer starts from this question.
Got a different question?Ask your own question
More Physics Questions
QA welder joined three pieces of metal as shown below. Work out the angle marked Z.QThe symbol below shows the use of what type of weld?QA weld cap is excessively high above the pipe surface. This condition may: A. Cause stress…QMeasure each of the angles.QWorkpiece or Base Metal: This is the material being welded.