This chemistry question involves key chemical concepts and calculations. The detailed solution below walks through each step, from identifying the reaction type to computing the final answer.
ScanSolve AI Answer
Here are the answers to the conceptual parts of your lab report template. You will need to fill in the "Observations" and "Conclusion" sections based on your own experimental data. Hypothesis Question: Do you think you can make AC water safe to drink using household materials? Why? Hypothesis: Yes, it is possible to make AC water cleaner using a simple filtration system with household materials. However, making it safe to drink would likely require an additional disinfection step (like boiling) to eliminate microorganisms, as filtration alone may not remove all harmful bacteria or viruses. Method How can I purify AC water step by step using a simple filtration system? 1. Obtain a clean plastic bottle and cut off the bottom. 2. Invert the bottle and place a layer of cotton at the neck, acting as the base filter. 3. Add a layer of fine sand on top of the cotton. 4. Add a layer of small stones on top of the sand. 5. Add a layer of large stones on top of the small stones. 6. Place the inverted bottle (your filter) over a clean collection container. 7. Slowly pour the collected AC water through the layers of the filter. 8. Collect the filtered water. 9. For disinfection, boil the filtered water for at least one minute to kill any remaining microorganisms. Observations Collection (Field work): This section requires you to collect data from an AC unit over 8 hours. Please fill in the Start Time, End Time, and Volume of Water Collected (mL) for each time interval, then calculate the Total water collected*. Water purification (Lab work): This section requires you to record observations Before Filtering and After Filtering for Water colour, Smell, and Dirt/particles. Also, note any Notes / Changes* observed during the process. The science (Why it works) a) How is AC water created in the air conditioning unit? AC water is created through condensation. When warm, humid air from a room passes over the cold evaporator coils inside the air conditioning unit, the water vapor (gas) in the air cools down, loses energy, and changes into liquid water droplets. These droplets then collect and drain out of the unit. b) What changes in states of matter can you observe in the water? The primary change in the state of matter observed is condensation, where water vapor (a gas) in the air transforms into liquid water. c) Why is filtering and disinfecting necessary? Filtering is necessary to remove physical impurities such as dust, dirt, and debris that may have been present in the air or accumulated within the AC unit's drainage system. Disinfecting is crucial because AC water, despite being formed from condensation, can still contain harmful bacteria, mold, and other microorganisms that could make it unsafe to drink. d) How does each layer of your filter work? (large stones, small stones, sand, and cotton) Large stones:* These act as the first layer, removing the largest particles and debris like leaves, twigs, and coarse sediment. Small stones:* This layer filters out smaller suspended particles that passed through the large stones. Sand:* The sand layer provides finer filtration, trapping even smaller particles and fine sediment due to its smaller pore spaces. Cotton:* This is the final and finest filtration layer, designed to remove very fine suspended particles and prevent the sand from washing out. Conclusion a) Was your hypothesis correct? You will answer this based on your observations and whether the filtered and disinfected water appeared cleaner and safer. b) Did the filter work? Was the water cleaner or safer to drink? You will answer this by comparing your "Before Filtering" and "After Filtering" observations and considering the effectiveness of your disinfection step.